Mike,
I think you'd need to disable keepalives on the interface you enable
loopback on.
Also in addition to pings, to verify, you can look at extended info on the
interface and check on the Sonet
PATH messages.
Hope it helps.
----- Original Message -----
From: "Mike"
To:
Sent: Saturday, September 22, 2001 8:14 AM
Subject: How can i do loopback test on the POS interface? [9:573]
> As you know,you can use the command -loopback internal or line to
> make sure the local is correct on the CISCO GSR POS interface.
> you can use the extended ping to make sure this.
>
> But,how can i make a loopback test on juniper router?
> I tried the command-
> Set interfaces so-0/0/0 sonet-options loopback local(remote).
>
> How can make sure the local or the remote is correct?
>
> I hope your answer,thank you!
>
>
> networkcn@xxxxxxx
> 9/22
http://www.groupstudy.com/list/juniper.html
Message Posted at:
http://www.groupstudy.com/form/read.php?f=9&i=574&t=573
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/juniper.html
