The default priority is one.
It's always better to set on the interface rather than the neighbor command
to assure consistent results!
Being a default though, it doesn't show up in running configuration.
HTH,
Scott
-----Original Message-----
From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx]
Sent: Tuesday, August 26, 2008 10:52 AM
To: cisco@xxxxxxxxxxxxxx
Subject: ospf priority [7:132392]
Hello,
In the book it says that if you don't set priority, then the router will
dynamically put in priority 1 and you will see it in the configuration like
this:
sh run | beg router ospf 1
router ospf 1
network 10.0.0.0 0.0.0.255 area 0
neighbor 10.1.1.1 priority 1
I have never seen this happen, and I can't make it happen. Does this really
happen? And what are the conditions to make it happen?
ken
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=132393&t=132392
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
