I am sure I have tried this but will try again.
ThanksHouse Mr Darren wrote:
>
> Not sure if this is the issue, but for the 2500's, 4000's &
> 45/700's in
> interface config mode, there is an interface type command
> (10BaseT or AUI).
> If I remember it right, you need to be sure the type is 10BaseT
> if you are
> using a transceiver.
>
> -----Original Message-----
> From: Jim Hendry [mailto:nobody@xxxxxxxxxxxxxx]
> Sent: Thursday, February 26, 2004 4:04 AM
> To: cisco@xxxxxxxxxxxxxx
> Subject: 2503 e0 (AUI +Transceiver) to communicate with a p
> [7:84950]
>
>
> I am experiencing problems with the above. I cannot seem to get
> 2503 e0 (AUI
> +Transceiver) to communicate with a port on Catalyst 2900, i.e.
> no LED's on
> switch. Port and line protocol down on 2900 and only port up on
> 2503, i.e.
> line protocol down
>
> I have tried changing port speed/duplex,etc @ 2950 but nothing
> works.
>
> I know transceiver, cables, etc are all good because it works
> if I
> disconnect 2503 from 2950 and connect to small (non-Cisco) hub.
>
> Any help appreciated.
>
> Jim
> **Please support GroupStudy by purchasing from the GroupStudy
> Store:
> http://shop.groupstudy.com
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> **Please support GroupStudy by purchasing from the GroupStudy
> Store:
> http://shop.groupstudy.com
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
>
>
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=85136&t=85130
--------------------------------------------------
**Please support GroupStudy by purchasing from the GroupStudy Store:
http://shop.groupstudy.com
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
