you wrote:
>-----Original Message-----
>From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx]
>Sent: Thursday, February 26, 2004 11:16 AM
>To: cisco@xxxxxxxxxxxxxx
>Subject: RE: 2503 e0 (AUI +Transceiver) to communicate with a
>p [7:84981]
>
>
>Not sure if this is the issue, but for the 2500's, 4000's & 45/700's in
>interface config mode, there is an interface type command
>(10BaseT or AUI).
>If I remember it right, you need to be sure the type is
>10BaseT if you are
>using a transceiver.
= = =
I know the command you are talking about it. However, I own three 2503's
and have never had to use it so I think this is not a likely source of
his problem.
**Please support GroupStudy by purchasing from the GroupStudy Store:
http://shop.groupstudy.com
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=85037&t=85037
--------------------------------------------------
**Please support GroupStudy by purchasing from the GroupStudy Store:
http://shop.groupstudy.com
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
