GroupStudy.com GroupStudy.com - A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
dlsw+ bet/ an enet rtr & t/r rtr [7:46896] posted 06/18/2002
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]


two questions...thx in advance!

1. is the "source-bridge transparent" command required on the token ring
router when one dlsw peer is ethernet only & the other dlsw peer is token
ring only (i.e., bet/ r1-e1 & r2-to1)?

2. why is the virtual ring (500) required on the ethernet router in the
config below?

finally, i understand that in the following config, the "source-bridge
transparent" command is required bec/ ethernet & token ring is off the same
router

!ethernet router:

source-bridge ring-group 500
dlsw local-peer peer-id 1.1.1.1
dlsw remote-peer 0 tcp 2.2.2.2 lf 1500
dlsw bridge-group 5
bridge-group 5 protocol ieee
!
int e0
ip address 1.1.1.1 255.255.255.0
bridge-group 5

!ethernet/token ring router:

source-bridge ring-group 500
source-bridge transparent 500 1000 1 5
dlsw local-peer peer-id 2.2.2.2
dlsw remote-peer 0 tcp 1.1.1.1 lf 1500
dlsw bridge-group 5
bridge-group 5 protocol ieee
!
int e1/2
ip address 2.2.2.2 255.255.255.0
bridge-group 5
!
int to0
ring-speed 16
source-bridge 7 1 500
source-bridge spanning

Timur Mirza
Principal Network Engineer
Network Planning & Engineering, West Region
15505-B Sand Canyon Avenue
Irvine, California 92618
Verizon Wireless
949.286.6623 (o)
949.697.7964 (c)




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=46896&t=46896
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to abuse@xxxxxxxxxxxxxx