- A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
RE: FXS cards - 1751 [7:45977] posted 06/08/2002
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]

Perhaps you have only a 2V DSP chip in the router (PN=PVDM-4)!?!?

Issue a Show Diag at the Exec Mode prompt, and see if it says DSPs = 2
or 4.

If it's 2, then that answers your question about not being able to
configure more then 2 voice ports.

But, somehow I would think that if you only had 2 DSPs, then you would
only have 2 of the 4 FXS ports initialized.

Perhaps you should do a "wr era" (if it's not a production router) and
then bounce that bad boy to see if you get different results.  You might
even see about rolling back to 12.2(4)T and see if that makes a


-----Original Message-----
From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx] On Behalf Of
George Siaw
Sent: Thursday, June 06, 2002 7:19 PM
To: cisco@xxxxxxxxxxxxxx
Subject: FXS cards - 1751 [7:45977]


Any ideas why there are only to voice ports to be configured?

Runcorn-1750>sh ver
Cisco Internetwork Operating System Software 
IOS (tm) C1700 Software (C1700-K8SV3Y7-M), Version 12.2(8)T1,  RELEASE
TAC Support:
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 30-Mar-02 15:07 by ccai
Image text-base: 0x80008108, data-base: 0x80F66930

ROM: System Bootstrap, Version 12.0(3r)T1, RELEASE SOFTWARE (fc1)

Runcorn-1750 uptime is 0 minutes
System returned to ROM by power-on
System image file is "flash:c1700-k8sv3y7-mz.122-8.T1.bin"

cisco 1750 (MPC860T) processor (revision 0x801) with 36864K/12288K bytes
of memory.
Processor board ID JAD06090DEV (2308858941), with hardware revision 0000
MPC860T processor: part number 0, mask 32
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
1 ATM network interface(s)
4 Voice FXS interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x210


Message Posted at:
FAQ, list archives, and subscription info:
Report misconduct and Nondisclosure violations to abuse@xxxxxxxxxxxxxx