GroupStudy.com GroupStudy.com - A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
Static LSP posted 11/05/2008
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]


Expert,
I was trying to configure a static LSP with manual labe binding and
swapping, just as a learning exercise, no special use of it.

On a P device I want it to swap input label 1001 with output label 1002
but this is what I get. Please not that according to:
http://www.cisco.com/en/US/docs/ios/mpls/configuration/guide/mp_vrf_aware_static.html
it should work.
Any alternative for a static LSP?
Thanks,
bit

p1#configure terminal 
Enter configuration commands, one per line.  End with CNTL/Z.
p1(config)#mpls label range 16 1000 static 1001 1099               
p1(config)#mpls static crossconnect 1001 Serial1/0 192.168.0.2 1002
% This command is an unreleased and unsupported feature
p1(config)#
*Nov  5 22:55:20.611: %LSD-4-BADAPI: illegal QoS value 0 from STATIC
p1(config)#
p1(config)#do show run | i mpls
mpls static
mpls label range 16 1000 static 1001 1099
mpls static labelswitch 1001 qos uninitialized

p1(config)#do br | ex una
Interface                  IP-Address      OK? Method Status
Protocol
Serial1/0                  192.168.0.2     YES NVRAM  up
up      
Serial1/1                  192.168.0.1     YES NVRAM  up
up      
Loopback0                  192.168.255.11  YES manual up
up      
p1(config)#do show ver
Cisco IOS Software, 7200 Software (C7200-ADVIPSERVICESK9-M), Version
12.4(20)T, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Fri 11-Jul-08 04:22 by prod_rel_team

ROM: ROMMON Emulation Microcode
BOOTLDR: 7200 Software (C7200-ADVIPSERVICESK9-M), Version 12.4(20)T,
RELEASE SOFTWARE (fc3)