 |
 |
|||||||||||||||||||
|
||||||||||||||||||||
|
Re: show command posted 08/09/2007
|
Thats a good one Leigh Thanks Ben On 8/9/07, Leigh Harrison <ccileigh@xxxxxxxxx> wrote: > > Have you seen the "section" commands? > > Try something along the lines of:- > > show run | section eigrp > (presuming you're running eirgp....) > > Check this:- > C1# > C1#sh run | section router rip > router rip > version 2 > no auto-summary > ! > address-family ipv4 vrf network12 > redistribute bgp 100 metric 5 > network 172.16.0.0 > no auto-summary > version 2 > exit-address-family > C1# > C1# > C1# > C1# > > Enjoy!! > > LH > #15331 > > > CCIEDAVITO CCIEDAVITO wrote: > > just found a great command to verify configuration per interface. > > > > show run int s 0/0 > > > > or > > > > show run int f 0/0 > > > > _______________________________________________________________________ > > Subscription information may be found at: > > http://www.groupstudy.com/list/CCIELab.html > > _______________________________________________________________________ > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
