first find out the ip address:
debug tcp transactions
then configure the neighbour with any as you want, IOS will tell you the AS
number that peer is in.
On 6/3/07, edassery@xxxxxxxxx <edassery@xxxxxxxxx> wrote:
>
> Hello Group,
> I have a doubt. Following are the config of R1 &R2
>
> R1
> Router bgp 100
> neighbor 192.168.10.1 remote-as 101
>
>
> R2
>
> router bgp 200
> neighbor 192.168.10.2 local-as 101
>
> Assuming that we do not have access to the R1 ,are there any debug
> commands that can be run on R2 to find the remote-as value and IP that is
> configured on R1.
>
> It will be great if you list out commands for this
>
>
> Rimpoche
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
--
Best regards,
Dan
