Do a debug ip bgp
Look for message like this
1d13h: BGP: 13.1.1.1 OPEN has CAPABILITY code: 2, length 0
1d13h: BGP: 13.1.1.1 OPEN has ROUTE-REFRESH capability(new) for all address-families
1d13h: BGP: 13.1.1.1 bad OPEN, remote AS is 40, expected 10 <--------
1d13h: BGP: 13.1.1.1 went from OpenSent to Closing
edassery@xxxxxxxxx wrote:
Hello Group,
I have a doubt. Following are the config of R1 &R2
R1
Router bgp 100
neighbor 192.168.10.1 remote-as 101
R2
router bgp 200
neighbor 192.168.10.2 local-as 101
Assuming that we do not have access to the R1 ,are there any debug commands that can be run on R2 to find the remote-as value and IP that is configured on R1.
It will be great if you list out commands for this
Rimpoche
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
---------------------------------
Luggage? GPS? Comic books?
Check out fitting gifts for grads at Yahoo! Search.
