GroupStudy.com GroupStudy.com - A virtual community of network engineers
Home BookStore StudyNotes Links Archives StudyRooms HelpWanted Discounts Login
Re: Reflexive access-list posted 06/02/2007
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]
Hi Guys,

Please whats the purpose of the "dce-terminal-timing-enable" command
on the serial interface?

Thanks

On 6/2/07, premkumar somasundaram <premkumar.somasundaram@xxxxxxxxx> wrote: 
Group.
I have a issue with the reflexive access-list. Here is the scenario.... I
need to configure reflexive access-list on R3 to allow ICMP, TCP, UDP and
OSPF traffic from inside to outside. The configuration is follows.


interface Serial2/3
 ip address 136.1.23.3 255.255.255.0
 ip access-group INBOUND in
 ip access-group OUTBOUND out
 encapsulation ppp
 clock rate 64000
 no dce-terminal-timing-enable


ip access-list extended INBOUND
 evaluate MIRROR
ip access-list extended OUTBOUND
 permit icmp any any reflect MIRROR
 permit tcp any any reflect MIRROR
 permit udp any any reflect MIRROR
 permit ospf any any reflect MIRROR
!

For testing, I used to ping for ICMP, Telnet for TCP , and Routing protocol
for OSPF.

But none of them worked...I am sure something is missing from the config
which i could nt find out..can any one help me on this...


Thanks
Prem

_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html