GroupStudy.com GroupStudy.com - A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
RE: Etehrchannel posted 11/14/2006
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]


Core-3750-1#sh int po1
Port-channel1 is up, line protocol is up (connected)
  Hardware is EtherChannel, address is 0015.6326.1c19 (bia
0015.6326.1c19)
  MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Full-duplex, 1000Mb/s, link type is auto, media type is unknown
  input flow-control is off, output flow-control is unsupported
  Members in this channel: Gi1/0/25 Gi1/0/28

Yoshe;

Notice BW = 2000000 Kbit, also notice Members in this channel = Gi1/0/25
& 28 which shows I have two gigabit interfaces bundled together for a
combined bandwidth of 2Gbps or 2000000 Kbit.

Hope this helps.
Adam

-----Original Message-----
From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx] On Behalf Of
Yoshe Rionando
Sent: Tuesday, November 14, 2006 10:59 PM
To: ccielab@xxxxxxxxxxxxxx
Subject: Etehrchannel 

Hi Folks,
How to verify speed of etherchannel. For example if i configure 3 port 
fastethernet to etherchannel, how can i verify that speed is 300 mbps?


Yoshe Rionando Y.
PT. Swadharma Duta Data
Network & System Engineering Dept.
Senior Network Engineer
phone  : 62 21 8318881
fax        : 62 21 8297293
mobile : 62 8159084895

_______________________________________________________________________
Subscription information may be found at: 
http://www.groupstudy.com/list/CCIELab.html