GroupStudy.com GroupStudy.com - A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
Re: Forward all voip traffic to gateway posted 10/12/2004
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]


Anand,
I'm afraid your question fall unders the classic "deleberate ambiguity
in the lab?". There are two ways of performing a task and BOTH are
correct and both are ok'ed by cisco at one place or another, now which
method to follow in the actual lab exam ? Thats is what keeps me
confused also .. dunno.. perhaps a seasoned ccie with half a dozen
attempts under his belt might help !!

Regards

Zafar


On Tue, 12 Oct 2004 07:35:20 -0700, Anand Singh <anandksi@xxxxxxxxx> wrote:
> Zafar,
> 
> Thanks for the reply. I understand the meaning but I am not sure if I loose
> points if I configure one or other way. I verified with "csim sta xxx" and
> both work fine. The questiion simply says "configure router to forward all
> voip traffic to gateway".
> 
> Thanks
> -Anand
> 
> 
> 
> > -----Original Message-----
> > From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx] On
> > Behalf Of Zafar Khan
> > Sent: Monday, October 11, 2004 9:18 PM
> > To: Anand Singh
> > Cc: Campbell, Mark; ccielab@xxxxxxxxxxxxxx
> > Subject: Re: Forward all voip traffic to gateway
> >
> >
> > Anand,
> >
> > http://cisco.com/en/US/products/sw/iosswrel/ps1835/products_co
> > nfiguration_guide_chapter09186a0080080aec.html
> >
> > %  Indicates that the preceding digit occurred zero or more
> > times. This functions the same as the "*" used in regular expression.
> >
> > T  Indicates the interdigit timeout. The router pauses to
> > collect additional dialed digits.
> >
> >
> > HTH
> >
> > Regards
> > Zafar
> >
> >
> >
> > On Mon, 11 Oct 2004 08:49:15 -0700, Anand Singh
> > <anandksi@xxxxxxxxx> wrote:
> > > Mark,
> > >
> > > I forgot to mention that I tested and both of these command's work.
> > >
> > > -Anand
> > >
> > >
> > >
> > > > -----Original Message-----
> > > > From: Campbell, Mark [mailto:campbell.mark@xxxxxxxxxxx]
> > > > Sent: Monday, October 11, 2004 8:23 AM
> > > > To: Anand Singh; ccielab@xxxxxxxxxxxxxx
> > > > Subject: RE: Forward all voip traffic to gateway
> > > >
> > > >
> > > > Hi Anand,
> > > >
> > > > The best way test this would be to "debug dialpeer" and do "csim
> > > > start (random number)" and see if there's a match to the dial-peer
> > > > voice instance you used .% in...(otherwise just use your
> > > > phone instead of
> > > > csim.)
> > > >
> > > > Regards,
> > > > Mark
> > > >
> > > > -----Original Message-----
> > > > From: nobody@xxxxxxxxxxxxxx
> > [mailto:nobody@xxxxxxxxxxxxxx] On Behalf
> > > > Of Anand Singh
> > > > Sent: Monday, October 11, 2004 4:22 PM
> > > > To: ccielab@xxxxxxxxxxxxxx
> > > > Subject: Forward all voip traffic to gateway
> > > >
> > > > Hello All,
> > > >
> > > > If i have to configure router to forward all voip traffic to the
> > > > voice gateway, can i use the following config:
> > > >
> > > > dial-peer voice 3 voip
> > > >  destination-pattern .%
> > > >  session target ipv4:3.3.3.3
> > > > !
> > > >
> > > > What' the difference between this and using "destination-pattern
> > > > .T". I know later will tell router to wait for interdigit timeout
> > > > before placing the call but is both config valid for above
> > > > requirement?
> > > >
> > > >
> > > > Thanks
> > > > -Anand
> > > >
> > > > ______________________________________________________________
> > > > _________
> > > > Subscription information may be found at:
> > > > http://www.groupstudy.com/list/CCIELab.html
> > >
> > >
> > ______________________________________________________________________
> > > _
> > > Subscription information may be found at:
> > > http://www.groupstudy.com/list/CCIELab.html
> > 
> > ______________________________________________________________
> 
> 
> > _________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html