Hi,
See below,
Best Regards,
William Chen
>
> 1H%s*L: "Packet Man" <ccie2b@xxxxxxxxxxx>
> $i4A: 2004/03/12 ,P4A$- $W$H 09:47:49 GMT+08:00
> &,%s*L: ccielab@xxxxxxxxxxxxxx
> %D&.: Multicast - ip pim
>
> Hi guys,
>
> Where should ip pim sparse-dense-mode be enabled when an interface has
> subinterfaces?
I think you should only enable PIM on interface which had configure IP.
> If it's enabled on the physical interface, will the subinterfaces inherit
> the setting?
No, I don't think so.
> What show command (besides show run) can I use to check if an interface has
> been configured for sparse-dense mode?
show ip pim interface.
_________________________________________________________________
> FREE pop-up blocking with the new MSN Toolbar get it now!
> http://clk.atdmt.com/AVE/go/onm00200415ave/direct/01/
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
Best Regards,
William Chen
