GroupStudy.com GroupStudy.com - A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
Re: OSPF on NBMA Networks posted 03/06/2003
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]


You also need ip ospf priority config on the interfaces to designate who the
DR is.

----- Original Message -----
From: "Tony Schaffran" <tschaffran@xxxxxxxxxxxxxxxx>
To: "Scot Peter" <scotsman@xxxxxxxxxxxxxx>; <ccielab@xxxxxxxxxxxxxx>
Sent: Thursday, March 06, 2003 1:36 PM
Subject: Re: OSPF on NBMA Networks


> It sounds like you just need the neighbor statements.
>
>
>
> Tony Schaffran
> Network Analyst
> CCIE #11071
> CCNP, CCNA, CCDA,
> NNCSS, NNCDS, CNE, MCSE
>
> www.cconlinelabs.com
> "Your #1 choice for Cisco rack rentals."
>
>
> ----- Original Message -----
> From: "Scot Peter" <scotsman@xxxxxxxxxxxxxx>
> To: <ccielab@xxxxxxxxxxxxxx>
> Sent: Thursday, March 06, 2003 4:54 AM
> Subject: OSPF on NBMA Networks
>
>
> > Hello Group
> >
> > If we need to configure OSPF on a Multipoint interface with the
> > following condition,
> > - R1 should use Multipoint interfaces,
> > - R2, R3 should not use subinterfaces,
> > - All three routers should be in the same Network.
> > - Don't configure Network type Broadcast or non-broadcast.
> >
> >     R1
> >    /  \
> > R2 R3
> >
> > I am not sure about configuring "ip ospf network
> > point-to-multipoint" (As the question mentions not to configure
> > Non-broadcast) or do we need to configure using "neighbor"
> > command? Please advice me on this.
> >
> > Regards
> > Pet