ustom Queuing question

[jim.phillipo@xxxxxxxxxxxx]

It says on the Cisco DOC that you cannot use Queue 0 for traffic other than
the assigned system traffic.

Yet when I add the command :r3(config)# queue-list 2 protocol ip 1 

Then do a sho run: 

I get 
queue-list 2 protocol ipx 2
queue-list 2 protocol ip 0  (what gives)
queue-list 2 default 3
queue-list 2 queue 0 byte-count 1000
queue-list 2 queue 1 byte-count 1000
queue-list 2 queue 2 byte-count 1000
queue-list 2 queue 3 byte-count 1000

Any thoughts ?
_________________________________________________________________
Commercial lab list: http://www.groupstudy.com/list/commercial.html
Please discuss commercial lab solutions on this list.
__________________________________________________________________
To unsubscribe from the CCIELAB list, send a message to
majordomo@xxxxxxxxxxxxxx with the body containing:
unsubscribe ccielab