I don't think it is supported on point to point, you can put the commands on
but it doesn't seem to work. If you find out otherwise I would like to hear
about it. I tried this last night with no luck.
~-----Original Message-----
~From: Jeffery S Kimes [mailto:kimes@xxxxxxxxxx]
~Sent: Sunday, April 21, 2002 5:26 PM
~To: ccielab@xxxxxxxxxxxxxx
~Subject: Bridging Frame-Relay Point-to-Point Sub-Interfaces
~
~
~Can you bridge frame-relay point-to-point sub-interfaces?
~
~I know that you can on a multi-point interface, but can you on
~point-to-point?
~_________________________________________________________________
~Commercial lab list: http://www.groupstudy.com/list/commercial.html
~Please discuss commercial lab solutions on this list.
~
_________________________________________________________________
Commercial lab list: http://www.groupstudy.com/list/commercial.html
Please discuss commercial lab solutions on this list.
__________________________________________________________________
To unsubscribe from the CCIELAB list, send a message to
majordomo@xxxxxxxxxxxxxx with the body containing:
unsubscribe ccielab
