- A virtual community of network engineers
 Home  BookStore  StudyNotes  Links  Archives  StudyRooms  HelpWanted  Discounts  Login
RE: DLSW question from CCbootcamp lab 19 posted 08/08/2001
[Chronological Index] [Thread Index] [Top] [Date Prev][Date Next] [Thread Prev][Thread Next]

Hi Louie,
	Not wanting to be smartass but....have you considered the 'dynamic'
keyword. Check out page 3-19 in the DLSW design guide.

-----Original Message-----
From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx]On Behalf Of
louie kouncar
Sent: Thursday, 9 August 2001 8:54 AM
To: ccielab@xxxxxxxxxxxxxx
Subject: DLSW question from CCbootcamp lab 19


In lab 19 Task Two (Advanced DLSW Configuration), question number 5 states
the following:

Configure R6 for DLSW, configure a static resource for MAC address
4444.3333.2222. R2 is the only router that should have a DLSW connection to
Make sure that this connection is dynamic and only comes up if there is an
explorer destined for 4444.3333.2222....

Here is what I did:

R6  (config):

dlsw local-peer peer-id promiscuous
dlsw icanreach mac-exclusive
dlsw icanreach mac-address 4444.3333.2222 mask ffff.ffff.ffff

R2 (config):

dlsw local-peer peer-id
dlsw remote-peer 0 tcp

The problem is that the (show dlsw peers) command on R2 shows (CONNECT ALL
THE TIME), What am I missing??????????

TCP       CONNECT         43        43  conf      0    0   0

I am not sure what to do to make this a dynamic connection that comes up
only if needed (Per question).

Any help is appreciated....

Louie J. Kouncar
TCO3 Senior Data Center Engineer
WorldCom Web Hosting (Tysons)
**Please read:
**Please read:
To unsubscribe from the CCIELAB list, send a message to
majordomo@xxxxxxxxxxxxxx with the body containing:
unsubscribe ccielab