how to pass broadcast on dialer interfaces with ISDN?
This is rqd if I am configuring Appletalk or any broadcast based protocl on
DDR.
Thanks in advance
Murali
----Original Message Follows----
From: "Brian Van Benschoten" <vader@xxxxxxxxxxxx>
To: "Muralidhar Devarasetty" <dhar_murali@xxxxxxxxxxx>,
<ccielab@xxxxxxxxxxxxxx>
Subject: Re: broadcast traffic on dialer interface?????
Date: Fri, 22 Oct 1999 11:11:16 -0500
I'm assuming you are using an async interface to test with.
you may need the "async default routing" command
----- Original Message -----
From: Muralidhar Devarasetty <dhar_murali@xxxxxxxxxxx>
To: <ccielab@xxxxxxxxxxxxxx>
Sent: Wednesday, October 20, 1999 9:35 AM
Subject: broadcast traffic on dialer interface?????
> Hi all,
> How to pass broadcast traffic using dialer interfaces?
> When I configure appletalk over DDR if I use legacy DDR and use broadcast
> keyword every thing works fine,but when I use dialerprofile since I am
not
> able to mention broadcast key word my RTMP advertisements become
> unintresting eventhough I mention appletalk as intresting traffic in
> dialer-list.
>
> Any ideas ?
> Thanks
> MK
>
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
> _______________________________________________________
> To unsubscribe from the CCIELAB list, send a message to
> majordomo@xxxxxxxxxxxxxx with the body containing:
> unsubscribe ccielab
>
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
_______________________________________________________
To unsubscribe from the CCIELAB list, send a message to
majordomo@xxxxxxxxxxxxxx with the body containing:
unsubscribe ccielab
