Here is my new config, please note the change on illustration on
http://www.seventwentyfour.org press cisco then labb 1 .
""Claudia Walter"" wrote in message
news:200205011405.KAA30192@xxxxxxxxxxxxxxxxx
> Hey Mats,
>
> I am confused now, maybe I didn't read your description correctly last
time
> ... To me it looks like you have two different problems ...
>
> Reading your original description again:
>
>
****************************************************************************
> ...
> 1.)I tried to set IP-configuration on both e0 and s1 but either way I do
it
> it ends
> up after restart that both e0 and s1 is administrativly down.
> ...
> 2.) In enable mode I can get e0 to function with ping command, I also
could
> config s1 and confirm that it up but no ping will function.
> ...
>
>
****************************************************************************
> Just ignoring the first bit for now... Are you saying that the serial
> interface is up/up but you can't ping it? Or am I missing something here?
If
> it is showing up/down on the show int then it is likely to be a clocking
or
> an encapsulation problem. Before you start pinging around you should check
> on the router itself that everything is up and running.
> Marcus was right with pointing you to the next things to check
> encapsulation, clock rate settings, etc. (I just assumed that this was
> working previously...)
>
> You will need to have a look at the "show interface s1" output and maybe
> also the "show controllers"
> If you connect to routers you will have to specify clocking on one end of
> the serial link.
>
> Here is a very good link for trouble-shooting interface
>
>
http://www.cisco.com/univercd/cc/td/doc/cisintwk/itg_v1/tr1915.htm#xtocid195
> 5713
>
> Nice little homepage by the way ;-)
>
> Claudia
>
> -----Original Message-----
> From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx]On Behalf Of
> Mats Johannesson
> Sent: 01 May 2002 14:17
> To: associate@xxxxxxxxxxxxxx
> Subject: Re: Problems with config 2501 [1:9103]
>
>
> I have put up the configuration in my homepage:
> http://www.seventwentyfour.org on the menu doubleclick on Cisco then
> doubleclick on Lab1.
>
> I will publish my config later, ok!?!
>
> Have a nice day!!! /Mats
> ""Mats Johannesson"" wrote in message
> news:200204300843.EAA20427@xxxxxxxxxxxxxxxxx
> > Hi there!
> >
> > I have some big problems with one of my routers (2501 version 12), I
tried
> > to set IP-configuration on both e0 and s1 but either way I do it it ends
> up
> > after restart that both e0 and s1 is administrativly down.
> >
> > In enable mode I can get e0 to function with ping command, I also could
> > config s1 and confirm that it up but no ping will function.
> >
> > What should I do? /Mats
[demime removed a uuencoded section named labb1.txt which was 84 lines]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=9130&t=9103
--------------------------------------------------
Read http://www.groupstudy.com/list/guide.html before POSTING!
To change your subscription, read the directions on:
http://www.groupstudy.com/list/Associates.html
