Hey Mats,
I am confused now, maybe I didn't read your description correctly last time
... To me it looks like you have two different problems ...
Reading your original description again:
****************************************************************************
...
1.)I tried to set IP-configuration on both e0 and s1 but either way I do it
it ends
up after restart that both e0 and s1 is administrativly down.
...
2.) In enable mode I can get e0 to function with ping command, I also could
config s1 and confirm that it up but no ping will function.
...
****************************************************************************
Just ignoring the first bit for now... Are you saying that the serial
interface is up/up but you can't ping it? Or am I missing something here? If
it is showing up/down on the show int then it is likely to be a clocking or
an encapsulation problem. Before you start pinging around you should check
on the router itself that everything is up and running.
Marcus was right with pointing you to the next things to check
encapsulation, clock rate settings, etc. (I just assumed that this was
working previously...)
You will need to have a look at the "show interface s1" output and maybe
also the "show controllers"
If you connect to routers you will have to specify clocking on one end of
the serial link.
Here is a very good link for trouble-shooting interface
http://www.cisco.com/univercd/cc/td/doc/cisintwk/itg_v1/tr1915.htm#xtocid195
5713
Nice little homepage by the way ;-)
Claudia
-----Original Message-----
From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx]On Behalf Of
Mats Johannesson
Sent: 01 May 2002 14:17
To: associate@xxxxxxxxxxxxxx
Subject: Re: Problems with config 2501 [1:9103]
I have put up the configuration in my homepage:
http://www.seventwentyfour.org on the menu doubleclick on Cisco then
doubleclick on Lab1.
I will publish my config later, ok!?!
Have a nice day!!! /Mats
""Mats Johannesson"" wrote in message
news:200204300843.EAA20427@xxxxxxxxxxxxxxxxx
> Hi there!
>
> I have some big problems with one of my routers (2501 version 12), I tried
> to set IP-configuration on both e0 and s1 but either way I do it it ends
up
> after restart that both e0 and s1 is administrativly down.
>
> In enable mode I can get e0 to function with ping command, I also could
> config s1 and confirm that it up but no ping will function.
>
> What should I do? /Mats
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=9124&t=9103
--------------------------------------------------
Read http://www.groupstudy.com/list/guide.html before POSTING!
To change your subscription, read the directions on:
http://www.groupstudy.com/list/Associates.html
