Dear all,
Two of my clients connect to my system thru ISDN connection.
I noticed that they could not get more than 56k.
How I can give them there full 64k thru there connection.
Here is the show int dialer2 as an example:
you'll find that the BW=56k how can I make it 64k.
purenet#s int dialer2
Dialer2 is up (spoofing), line protocol is up (spoofing)
Hardware is Unknown
Description: digma router
Interface is unnumbered. Using address of Ethernet0/0 (64.86.163.1)
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Please help....
Regards,
Magdy
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=2605&t=2605
--------------------------------------------------
You are reading GroupStudy's Associate Mailing List. To unsubscribe follow
the directions on http://www.groupstudy.com/list/Associates.html
