Hi guys,
I have 2 questions
1) First, I have a router in production that I monitor, I recieved a trap
on it, when I went in I could see in the log that the router had restarted,
and that a few DLCI's changed status to deleated, I later found out that
those DLCI's were no longer in production, some are still in use, to avoid
further confusion I would like to remove the unused DLCI's, but I'm not sure
how to go about it, another detail I should mention is that this is takeing
place on a Serial 0 like I said it has several DLCI's configured on the same
interface
2) This is a easyer question, on another router sub-interfacer were
configures, s0.1, s0.2, s0.3, s0.4......, it was in use for frame-relay,
they are no longer in use, I can do a SHUT on them, but how would I remove
them from the config compleatly
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=1428&t=1428
--------------------------------------------------
You are reading GroupStudy's Associate Mailing List. To unsubscribe follow
the directions on http://www.groupstudy.com/list/Associates.html
