If you were coping from a tftp server, I'm not sure why you changed the baud
rate for the console. But anyway, the reason your config reg. looks funky
is that the console baud rate is changed via the config reg. To correct the
problem, get into config mode, configure line con 0 , change the baud rate.
This should do it for you.
-----Original Message-----
From: nobody@xxxxxxxxxxxxxx [mailto:nobody@xxxxxxxxxxxxxx]On Behalf Of
zuszus
Sent: Monday, January 08, 2001 5:52 PM
To: associate@xxxxxxxxxxxxxx
Subject: configuration register [1:1395]
i am a network administrator of CORVIT SYSTEMS PRIVATE LIMITED PAKISTAN.I
JUST CHANGED TJE CONFIGURATION REGISTOR VALUE to 0x2101 OF MY cisco routers
( cpa 2501),and reloaded. after that they are not get started.i erased the
flash and reloaded from tftp in rom monitor mode.
i was working on console and changed the speed as well.fist i copied the
flash assuming its corrupted in the router rom moniter mode , but all my
efforts ended in in vain. when the router started again changing the conf
.register value to 0x2102 to boot from flash , it s dispaced the followung
error
time error(change configuration register 0x108)
please help.
khawaja usman mahmood
zuszus@xxxxxxxxx
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=1395&t=1395
--------------------------------------------------
You are reading GroupStudy's Associate Mailing List. To unsubscribe follow
the directions on http://www.groupstudy.com/list/Associates.html
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=1408&t=1395
--------------------------------------------------
You are reading GroupStudy's Associate Mailing List. To unsubscribe follow
the directions on http://www.groupstudy.com/list/Associates.html
Message Posted at:
http://www.groupstudy.com/form/read.php?f=1&i=1411&t=1395
--------------------------------------------------
You are reading GroupStudy's Associate Mailing List. To unsubscribe follow
the directions on http://www.groupstudy.com/list/Associates.html
